Airsoft Systems ASCU Gen. 5+ for V3 Gearbox

SKU bat_ascugen5v3
  • The 5th generation ASCU has been in development and extensively tested for 18 months. The main goal was to achieve an unmatched reliability and compatibility with the most of the existing motors and batteries used in airsoft.
  • With the 5th generation, Airsoft Systems have taken a completely new approach to the hardware, which eliminates the occurrence of any rare previous failures. The extensive tests have proven that ASCU3 Gen5 and ASCU3 Gen5 are extremely stable.
  • MosFet transistors with 16 times less resistance, resulting in faster cycling, better active braking, more shots per battery charge and less heat output.
  • New very strong trigger switch.
  • New reinforced design with full polymer encasing.
  • Better short-circuit protection.
  • Easier installation.
  • Updated software with easier programming (accidental hop-up program activation is impossible).
  • Improved cut-off lever.
  • Improved selector plate.
  • Fits all standard and reinforced version 2 gearboxes.
  • 3 year world wide warranty (via manufacturer).
  • The ASCU is a two piece electronic computer control unit for airsoft rifles that brings a new level of performance to standard AEGs, with features previously only seen on expensive training weapons.
  • The new 5+ generation unit is smaller and has more features. It has four selectable fire modes including three-round burst (selectable if the trigger is released before the third shoot in full-auto mode).
  • The ASCU Gen.5 system monitors the operation of the AEG at all times, so no matter how fast you tap the trigger, the AEG will always complete the full cycle, no matter if you shoot in Semi or Full Auto mode.
  • After each shot or burst the piston will stop in its forward-most position.
  • The trigger pull is crisp and much more realistic.
  • The control unit is very compact and can be placed in the stock tube, buttstock or handguard of any AK/G36C variant or most guns with a V3 gearbox.
    This kit is only suited to version 3 gearboxes.
  • The sensor unit completely replaces the existing switch assembly and wiring in the gearbox.
  • The ASCU monitors the actual position of the sector gear and stops the motor electronically once the sector gear has completed a full cycle. This eliminates the need for an anti-reversal latch. (This is very much dependant on your motor, some weaker motors will require the latch to remain in place).
  • It also reduces wear on virtually all internal components as the gearbox is never stopped mid-cycle.
  • The ASCU also massively increases trigger response and the rifles rate of fire, as well as the amount of shots per charge of the battery.
  • This kit is not battery sensitive, so you can use NICD, NIMH, LIPOs etc, from 7.2v to 12v.
  • It features an integrated Low Drain Protection system, specially designed to keep LiPo batteries from damaging themselves.
  • When using the ASCU it will detect when the magazine is empty and stop the AEG from shooting, preventing dry firing.
  • The ASCU Gen.5 will also stop the AEG firing if any mechanical problem occurs in the AEG, which protects the internals of the gearbox from further damage.
  • The unit is easy to install in all AEGs with a version 2 gearbox, but should be installed by a skilled technician. 

You recently viewed

Clear recently viewed