Perun Krytac Kriss Vector Mosfet

• Perun was founded in 2016 with the goal of developing and producing MOSFETs and other parts for airsoft replicas.

• Years of design and testing have allowed them to offer products that enhance the performance of your replica.

• Replaces the stock electronics in your Kriss Vector airsoft replica.

• It provides lots of additional features, including active braking and full cycle control, making sure that each cycle is finished, even if the trigger is pulled very briefly,

• Programming of all the settings is done solely by using the trigger and selector, in easily memorable and quick sequences.

• Programming is supported by sound signals and multicolor LED diode.

• That allows changing the settings in any moment, in a matter of seconds.

• Works without problems with any battery from 7.4v to 11.1v.

Features

• Freely programmable firing modes – Set any firing mode you like on any of the selector positions independently. Available modes are: safe, semi, binary, 2 to 5 round burst and auto.

• Active brake – active brake stops the motor after each shot preventing spring compression or in case of high rate of fire, overspin (double shot problem).

• Precocking – Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, piston will remain in rear position after each shot with the spring already compressed, ensuring that next shot will be fired immediately after you pull the trigger. To release the spring after using precocking, pull and hold the trigger. A second shot will be fired after 3 seconds, with no precocking and fully braked.

• Rate of fire reduction – Reduce the rate of fire in automatic or burst fire to save ammo or make the replica shoot in a more realistic fashion.

• Low battery voltage alarm – Dedicated for Li-Po and Li-Ion batteries. Should the battery voltage fall to a dangerously low level, user will be notified by short sound signals that are repeated every minute. This may also be freely switched on and off.

• Diagnostic system – Constantly monitors the replica and the mosfet itself. In case of any problems, immediately lets you know what it might be, making troubleshooting much easier.

• Electronic fuse – Will save your replica and battery in case of a major malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.